The Griffin Armament CAM-LOK QD piston is a quick-detach mounting system designed to replace the fixed direct-thread piston in your Dead Air Wolfman or Ghost suppressor. Built from 17-4 stainless steel and heat-treated to H900 specification, this piston solves one of the most frustrating problems with traditional pistol suppressors: they loosen during firing. Unlike single-piece direct-thread pistons that rely on hand-tightening and gradually work loose as your slide cycles, the CAM-LOK system uses a taper-lock interface and accepts a 3/4-inch socket wrench for secure, tool-tightened installation that stays put through hundreds of rounds.

If you've dealt with baffle strikes, end-cap hits, or the constant need to re-tighten your suppressor at the range, the CAM-LOK design eliminates that headache. The system features three mounting positions separated by 120 degrees, letting you attach your suppressor rapidly without fumbling with alignment. Because the mating diameters and interface geometry are held to tight manufacturing tolerances for squareness and concentricity, each mounting position delivers similar minimal point-of-impact shift—something you'll appreciate if you're running your suppressor on multiple hosts. The piston actuates freely during firing, but the internal taper surface locks it in place and drastically reduces or eliminates the baffle and end-cap strikes that plague loose systems.

This product is the piston alone (the bronze-colored part that installs inside your suppressor). You'll also need a compatible CAM-LOK barrel adapter for your specific pistol—sold separately—to complete the system. Once paired with an adapter, you can swap your suppressor between different CAM-LOK-equipped hosts without disassembling the can or changing pistons, and if you own other CAM-LOK-compatible suppressors, the barrel adapters are interchangeable across the platform. The total system weight matches legacy direct-thread pistons, so there's no added bulk or recoil signature penalty.

The Griffin Armament CAM-LOK QD piston is a quick-detach mounting system designed to replace the fixed direct-thread piston in your Dead Air Wolfman or Ghost suppressor. Built from 17-4 stainless steel and heat-treated to H900 specification, this piston solves one of the most frustrating problems with traditional pistol suppressors: they loosen during firing. Unlike single-piece direct-thread pistons that rely on hand-tightening and gradually work loose as your slide cycles, the CAM-LOK system uses a taper-lock interface and accepts a 3/4-inch socket wrench for secure, tool-tightened installation that stays put through hundreds of rounds.

If you've dealt with baffle strikes, end-cap hits, or the constant need to re-tighten your suppressor at the range, the CAM-LOK design eliminates that headache. The system features three mounting positions separated by 120 degrees, letting you attach your suppressor rapidly without fumbling with alignment. Because the mating diameters and interface geometry are held to tight manufacturing tolerances for squareness and concentricity, each mounting position delivers similar minimal point-of-impact shift—something you'll appreciate if you're running your suppressor on multiple hosts. The piston actuates freely during firing, but the internal taper surface locks it in place and drastically reduces or eliminates the baffle and end-cap strikes that plague loose systems.

This product is the piston alone (the bronze-colored part that installs inside your suppressor). You'll also need a compatible CAM-LOK barrel adapter for your specific pistol—sold separately—to complete the system. Once paired with an adapter, you can swap your suppressor between different CAM-LOK-equipped hosts without disassembling the can or changing pistons, and if you own other CAM-LOK-compatible suppressors, the barrel adapters are interchangeable across the platform. The total system weight matches legacy direct-thread pistons, so there's no added bulk or recoil signature penalty.