Availability: In Stock
The Angstadt Arms AA015HGMLT 15" ultra light aluminum handguard is a free-float M-LOK rail built for shooters who refuse to sacrifice control for weight savings. At just 9.4 ounces, this skeletonized handguard delivers a significant weight reduction without compromising mounting versatility or structural integrity—ideal for AR-15 builds where every tenth of a pound counts, whether you're running a precision rifle, a tactical carbine, or a dedicated 9mm platform.
The design philosophy here is straightforward: keep what matters, cut away the rest. Aggressive lightening cuts throughout the aluminum body reduce weight while the free-float design eliminates handguard-to-barrel contact, ensuring consistent accuracy across shooting scenarios. Installation is refreshingly simple—no timing required, just standard wrench work. You get M-LOK slots on all four sides (3, 6, 9, and 12 o'clock), a top-mounted mil-spec Picatinny rail with its own lightening cuts, and four QD points for sling or accessory mounting. The hardware is included, so you're ready to install out of the box.
A thoughtful detail for suppressed builds: the last ¾ inch of the handguard is bored to 1.405 inches inside diameter, allowing most aftermarket suppressors (up to 1.39 inches) to tuck inside. Compatible with both forged and billet upper receivers, the AA015HGMLT works with .223/5.56 and 9mm platforms. Available in mil-spec hard coat black anodize, Magpul FDE, or Tactical Grey Cerakote finishes.
This is purpose-built gear for shooters who understand their setup—no unnecessary bulk, no marketing fluff, just a well-engineered handguard that does its job and stays out of the way.
| Length | 15" |
| Weight | 9.4 oz (0.615 lbs) |
| Inner Diameter | 1.375" |
| Outer Diameter (last ¾") | 1.405" |
| Material | Aluminum, skeletonized |
| Finish Options | Mil-spec hard coat black anodize, Magpul FDE (Flat Dark Earth), Tactical Grey Cerakote |
| Mounting Interface | M-LOK® |
| Picatinny Rail | Top-mounted mil-spec 1913 with lightening cuts |
| QD Points | 4 |
| Caliber Compatibility | .223/5.56 and 9mm |
| Upper Receiver Compatibility | Forged and billet |
| Incompatible Calibers | .308 |
The handguard is compatible with AR-15 platforms in .223/5.56 and 9mm. It is not compatible with .308 or larger AR-10 builds.
If your suppressor is 1.39 inches in diameter or smaller, it should tuck inside the handguard—the last ¾ inch of the guard is bored to 1.405 inches inside diameter. Most modern aftermarket suppressors fall within this range, but verify your suppressor's exact diameter before purchasing.
No. The handguard requires no timing and installs with a standard wrench. All mounting hardware is included.
Yes, the AA015HGMLT works with both forged and billet upper receivers.
SKU: 115836016 • Width: 6.1in • Height: 4.4in • Depth: 20.8in • Weight: 1.5oz
